top of page

S5 WRC & GC8 Subaru Impreza Carbon Panels 

S5 WRC Infused Carbon Kits  

 

1997/98 S5 WRC Carbon Panels - 100% accurate to the S5 WRC works cars.

Full kit contains :-

2 x Carbon Rear Quarter Panels
2 x  Carbon Sills 
2 x  Carbon Front Wings 
1 x  Carbon Rear Bumper
1 x Carbon Fr Bumper, Fog Covers & Grill Badge Holder
1 x Carbon S5 1998 Tarmac Front Splitter 
2 x Twintex Front Arch Liners

S5 WRC Carbon Bonnet Vents & Under Trays   

2 x Prepreg Carbon Outer Vents & M4 Fixings

2 x Prepreg Carbon Under Trays

These have been meticulously scanned, re-drawn and are not only 100% accurate, but are a drastic improvement over the originals when it comes to fitment. Not only are they 100% symmetrical both sides, but our new under-trays now greatly aide the locating off them in the correct place on the bonnet & reduce the large fabrication work required on the bonnet apertures to countersink them as per on the originals. They also ensure the bonnet ribbing that is cut away is reinforced & closed off. Please note these are made to order with a 3-4 week turnaround.

S5 WRC Carbon Grill Badge Holder   

Made from Prepreg Carbon 

These have also been carefully scanned, re-drawn and are 100% accurate &

symmetrical unlike a lot of the original GRP ones.   

 

Please note these are made to order with a 1-2 week turnaround.

GC8 Impreza Carbon Bonnet   

 

This is a later 'face-lift' bonnet that was fitted to an Impreza from late 1997 until 2001. We produce these as infused carbon parts, which retain all the factory threaded fitments for the hinges and bonnet latch.

 

All OEM factory vent apertures are present and will allow the fitment of any OEM vent or 'after-market' vent that is designed to work with an OEM bonnet.  

Our carbon bonnets weigh in at a meagre 4.2kg, compared to an STI alloy bonnet which is 8.25kg. 

Please note these are made to order with a 3-4 week turnaround

S5 WRC Impreza Carbon Bonnet   

 

Similar to our 'face-lift' OEM bonnet that was fitted to an Impreza from late 1997 until 2001 and on all S5 WR cars of the same period - this is our standard OEM carbon bonnet with our S5 WRC Vent & Undertray kit pre-fitted to it. 

As before, this bonnet still retains all the factory threaded fitments for the hinges and bonnet latch & still weight in at a meagre 4.4kg

Please note these are made to order with a 3-4 week turnaround

GC8 Impreza Carbon Boot-lid Trunk   

 

Carbon Fibre boot-lid or trunk to suit all Impreza cars from 1993 until 2001. We produce these as infused carbon part, which retains all the factory threaded fitment's for the hinges and locking latch.

 

These are produced with the keyhole aperture removed, but this can easily reinstated if required, but we recommend the use of the internal bonnet release rather than use of the key .

These carbon bootlids are one of the greatest weight saving additions to any build as they weight in a at only  2.7kg  compared to an OEM one which is 9.5kg. 

Please note these are made to order with a 3-4 week turnaround

GC8 Impreza Carbon Fibre Roof Skin

 

Carbon Fibre boot-lid or trunk to suit all Impreza 4dr saloon & 2dr coupe cars from 1993 until 2001, produces in infused carbon.

 

These carbon roof skins are another one of the greatest weight saving additions to any build as they weight in a at only 2.4kg, compared to an OEM one which is 7.5kg.

 

For motorsport use only. If used on a road car we advise a half roll cage at minimum.

Please note, the roof skin shown has a 'herringbone' split centre line which we no longer do. All roof skins now have a solid weave running at a 45 degree angle

Please note these are made to order with a 3-4 week turnaround.

S5 WRC Rear Spoiler - Prepreg Carbon

One of the most impressive parts we produce are these stunning S5 WRC Prepreg Carbon Fibre rear spoilers. 

These were produced by scanning an original one - it was then re-drawn in Solidworks to make it symmetrical, as the originals are far from perfect.  We also scanned the boot lid for the underside plane, so both spoiler & boot lid mate-up millimetre perfect. These come with 8x pre-fitted M6 threaded inserts to mount it.

All joins are near invisible with little or no prep required prior to paint unlike the GRP ones. These weighs in at meagre 2.6kg, compared to GRP ones that weigh in at over 5kg.

Please note these are made to order with a 3-4 week turnaround

S5 WRC Bumper Fog Lamp Pods

S5 WRC Carbon Fibre front bumper, fog lamp pods.

 

For mounting Hella Rallye 3000 fog lamps. Sold as a pair. 

 

 

 

 

Please note these are made to order with a 3-4 week turnaround

CALL US
EMAIL US
OPENING HOURS

Mon - Fri: 8am - 5pm

COME AND VISIT US
  • Facebook Social Icon
  • Instagram Social Icon
  • YouTube Social  Icon

© 2023 by Dr. Repair. Proudly created with Wix.com

bottom of page